RegisterSearchFAQMemberlistUsergroupsLog in
Reply to topic Page 1 of 1
Dynojet Wideband Commander Wiring
Author Message
Reply with quote
Post Dynojet Wideband Commander Wiring 
Long time lurker first time poster so I've figured out you guys know just about everything. Smile Trying to figure out the wiring on a first generation Dynojet Wideband Commander. The O2 sensor is Bosch LSU 4.2 with the standard wire color to injector function (i.e. trim resistor is green, heater + is grey, etc.). The "O2 Sensor Connector Cable", which I do not have, tied into the box using non-standard colors. Building a new cable would be easy since the wide band O2 sensor uses a readily available GM/Bosch 6 way connector. Here's a link to the installation manual - http://www.widebandcommander.com/pdf/WBCInstallGuide.pdf

Thanks!
Sam

View user's profile Send private message
Display posts from previous:
Reply to topic Page 1 of 1
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum